Milwaukee pH Probe MA73600 is the replacement electrode designed for the Milwaukee PH51 and PH54 meter. Over time, the meter begins to give slow, unstable readings or fails to calibrate, and regular maintenance no longer manages to recover sensor performance. It is time to change the probe and discover the true pH.
Replacing the worn-out probe with a new one allows you to measure with confidence again and adjust fertilisation with greater certainty.
How to replace the Milwaukee pH Probe MA73600?
Installation is straightforward: remove the cap from the meter, unscrew the protective ring, remove the old probe and insert the new electrode into its housing. Then screw the ring back on and make sure the threads are tightened properly. After the change, it is essential to recalibrate the pH51/pH54 to guarantee correct readings.
Simple maintenance for longer electrode life
To extend the life of the electrode, avoid knocks and falls, rinse the tip after each use and always store it damp with specific storage solution (never with distilled or deionised water). Good maintenance reduces reading failures and improves stability in every measurement.
Technical Specifications of pH Probe for PH51 and PH54 by Milwaukee
- Manufacturer: Milwaukee
- Reference: MA73600
- Type: Replacement pH electrode / probe
- Compatibility: Milwaukee pH51 and Milwaukee pH54 meters
- Function: pH measurement in solutions (irrigation, reservoirs, nutrient mixes)
- Installation: Replacement via threaded protective ring (no tools required)
- Recommendation after change: Meter calibration
- Condition: New











